Loading Laminator Overlay - SD460 with Laminator

 

Load the overlay material in one laminator cartridge at a time. The L1 (green) and L2 (orange) cartridges fit only in their assigned locations inside the laminator. They are not interchangeable.

  • Open the laminator door.
  • Remove the L1 (green) laminator cartridge from the laminator. Place the cartridge on a smooth, level surface for loading.
  • Push the release latch and open the gate on the laminator cartridge.
  • Remove both used spools from the cartridge (if present).
  • Load the new roll of laminator overlay material.
    • Put the blue supply spool on the blue supply spindle of the cartridge. The overlay supply roll can go on only one way and only fits on the correct spindle.
    • Put the empty silver take‐up spool on the silver take‐up spindle.
    • Turn the take‐up spool clockwise to remove slack from the material. The overlay material loads in an S‐shape.
      • Make sure that the overlay material is between the guides on both the take‐up and supply sides of the cartridge.
  • Close the laminator cartridge gate. Push it in until the latch clicks in place. Make sure that the overlay material is not pinched by the cartridge gate.
  • Replace the loaded laminator cartridge in the printer.
  • Remove the L2 (orange) cartridge from the laminator, if installed.
  • Repeat steps 3 through 7 to load the overlay onto the cartridge.
  • Close the laminator door.
The End