Load Ribbon and Cleaning Sleeve - SD460 Laminator

 

Loading the Printer Ribbon
Load the ribbon when you install the printer and when the ribbon runs out.

  • Wind the take‐up spool counterclockwise one full turn.

Loading the Cleaning Sleeve
Load a new cleaning sleeve with each new roll of print ribbon, if you notice debris on the printed cards, or if the cleaning sleeve is no longer sticky. The printer ships with the cleaning roller spindle in the accessory box.

  • Locate the cleaning roller spindle and slide the spindle into the continuous cleaning sleeve.
  • Place the spindle with cleaning sleeve onto the ribbon cartridge.
  • Remove the protective wrapper from the cleaning sleeve.

Installing the Ribbon Cartridge
Install the assembled print ribbon cartridge into the printer.

  • Open the printer cover.
  • Hold the print ribbon cartridge by the handle and lower it into the printer with the handle toward the front of the printer.
  • Make sure that the ribbon cartridge is correctly positioned in the guides.
  • Close the printer cover. Press down on the ridges on the front of the cover to make sure that it latches completely on both sides.
The End